Bottlehead Forum

Bottlehead Kits => Crack => Topic started by: dusk on August 26, 2015, 07:16:53 AM

Title: vintage lamp assembly
Post by: dusk on August 26, 2015, 07:16:53 AM

I recently picked up a 6.3V vintage lamp assembly.. can I just bridge off the tuber warmer cables to power this, or will I need a resistor?

http://www.parts-express.com/parts-express-red-jewel-63v-tube-amp-pilot-light-assembly--070-450

Title: Re: vintage lamp assembly
Post by: caffeinator on August 26, 2015, 07:27:52 AM

Wire it in with the filaments; all should be in parallel with the filament winding.