Bottlehead Forum

General Category => General Discussion => Topic started by: frank bare on February 08, 2016, 05:02:00 AM

Title: Quickie left channel cuts out when I install RCAs
Post by: frank bare on February 08, 2016, 05:02:00 AM

Status on Quickie 1.1 and non-working  PJCCS board...

I decided to pull the board, unable to get left channel to work, no voltage to left side.

Powered up Quickie, rechecked voltages (all in spec) this is what I found:
 
1. With RCAs installed on input #1, left and Right work great.
2. When I install second set of RCAs, on input #2...it cuts out the left channel.

Why is this? All voltages good/wiring/tubes/interconnect double checked.

Could explain why PJCCS left channel does not work? Any help with the experts out there?
-thanks
Bare

Title: Re: Quickie left channel cuts out when I install RCAs
Post by: Paul Birkeland on February 12, 2016, 01:59:47 PM

Is there a difference between the cables that you're using?  Is there a solder bridge across one of the input jacks?

Generally this will not have any impact on the functionality of the PJCCS.