Bottlehead Forum

Bottlehead Kits => S.E.X. Kit => Topic started by: Mordicai on February 20, 2016, 12:36:53 PM

Title: Sex 2.1...Single resistance problem [resolved]
Post by: Mordicai on February 20, 2016, 12:36:53 PM: Finished up the Sex this morning. All resistance reading are spot on except A6 which reads 8.17. B6 reads 1.26 which is on the money. After a couple of hours I give up. Switched the tubes but no change. Everything else seems go to go. Wasn't sure it was safe to do a power up, so haven't done the voltage checks. Bad resistor? Don't think I fried it but who knows. Any suggestions at this point would be welcome.
Title: Re: Sex 2.1...Single resistance problem
Post by: fullheadofnothing on February 20, 2016, 01:02:11 PM: You switched a 1.27KÎ© resistor for an 8.2KÎ© resistor. Measure the 6/11 and 16/21 resistors (or just check color codes) to find your missing 1.27KÎ© resistor.
Title: Re: Sex 2.1...Single resistance problem
Post by: Mordicai on February 20, 2016, 01:10:27 PM: Oh yah! I have two 1.27 on one side and two 8.17 on the other. You've made my day. Thanks!