Bottlehead Forum

Bottlehead Kits => S.E.X. Kit => Topic started by: Lolovitch on February 27, 2016, 11:27:00 PM

Title: Building my SEX now, question on manual (resolved)
Post by: Lolovitch on February 27, 2016, 11:27:00 PM
Hi all,

I was awake at 3.30 this morning (thanks jetlag) and decided to use these quiet hours in the morning to start with my SEX. I have a quick question on how to understand the manual, if anybody can confirm that would be much appreciated.

On page 17 re the installation of the plate choke it reads: "Clip the black lead to 1” (25mm) and install some heat shrink tubing over the end (not shown cut in these photos)."

Am I right understanding that the black wire needs to be cut at 25mm, isolated with heat shrink and left unconnected?
Sorry if that seems obvious but I thought better asking before cutting. BTW what is this black wire and why leave it unconnected?
Title: Re: Building my SEX now, question on manual
Post by: mcandmar on February 28, 2016, 12:30:46 AM
Correct, the black wire is unused in the S.E.X. kit.
Title: Re: Building my SEX now, question on manual
Post by: Lolovitch on February 28, 2016, 12:59:54 AM
Correct, the black wire is unused in the S.E.X. kit.

Thanks mate!