Bottlehead Forum

Bottlehead Kits => Crack => Topic started by: mike langer on June 26, 2016, 08:58:28 PM

Title: overlong leads-i burnt some insulation near solder joints - removed burnt wire
Post by: mike langer on June 26, 2016, 08:58:28 PM

 insulation    and nothing is shorted can i leave like this ? or repair with liquid elec tape, regular elec tape or must leads be removed and resoldered? (lots of work) this is my first build and going great-my opinion
Thanks everybody

Title: Re: overlong leads-i burnt some insulation near solder joints - removed burnt wire
Post by: Doc B. on June 27, 2016, 04:35:33 AM

Posting a picture might be helpful. The best way is usually to disconnect the wire and slip a piece of heat shrink tubing over the bare section, then reconnect.