Bottlehead Forum
Bottlehead Kits => Crack-a-two-a => Topic started by: ALL212 on January 05, 2018, 11:56:50 AM
-
Bottom of page 46 - 6.3 electrolytic into the outboard holes of Y and Y+ on the B side.
The stack of three holes furthest from the mounting hole (bB) is NOT what I use. The single hole closest to the mounting hole is Y? The y+ side has no such confusion. The picture shows using the single hole on the Y.
I'm going with the picture but since it says outboard hole and Y only seems to have 1 hole I'm just checking.
THanks!
Aaron
-
The stack of three holes by bB is simply the connections to bB.
The Y+ and Y- (it's a bit easier to see the "-" on the other side of the board) are their own set of holes, with one set designed to fit a small resistor (33K in this case) and the other a bit heftier to support a capacitor.
-
Thanks PB! Much Appreciated.
Aaron