Bottlehead Forum
Bottlehead Kits => Legacy Kit Products => Crack-a-two-a => Topic started by: Jimb0 on May 11, 2018, 08:08:45 AM
-
I'm having a bit of trouble attaching the two heat sinks to one of my High Current C4S Boards. I understand it's suppose to snap in place. The other one was fine but this one just won't go in even with a good amount of force. Any tips to get it in?
-
I find that it's easier to set the heatsink on a countertop, then press the PC board into it.
If all else fails, the through plating on those holes isn't critical for the boards to function, so you could use a small round file to enlarge the holes.