Bottlehead Forum
Bottlehead Kits => Legacy Kit Products => Smash => Topic started by: tipatina on July 15, 2018, 10:50:00 AM
-
I disabled the loctal mechanism as per the manual but when I plugged in the tubes they were loose. So I crimped it a little and tried again and now they are in and locked good. I realize I'll need to be able to remove them some day. Any hints???
-
You can flip the Smash over and press them out from the bottom side. I'd worry about this when the tubes actually die, which could be a very long time.
-
Thanks for the advice. It looks like the 4P1L tubes may be less visible from underneath after Smashup installation but I guess still accessible?
-
Yes, you may have to unscrew a board.
A tiny flathead screwdriver may be able to pry the tube out as well.
-
Thanks, that worked