Bottlehead Forum
Bottlehead Kits => Eros Phono => Topic started by: gregoryahunter on August 19, 2018, 08:54:11 PM
-
I should probably know this - but I'd rather ask than have to remove something I soldered in because Im not very good at removing solder!
The picture in the assembly manual shows a white rectangular box as the "270W 5W wirewound resistor" (pic attached). I dont have anything like that in my kit. I have a green 270 Ohm 5W resistor (pic attached).
I assume that the "270W" in the manual is a misstype and the green 270 Ohm resistor that I have is the correct part?
Thanks in advance
-
Yes
-
THANKS!
-
I should probably know this - but I'd rather ask than have to remove something I soldered in because Im not very good at removing solder!
The picture in the assembly manual shows a white rectangular box as the "270W 5W wirewound resistor" (pic attached). I dont have anything like that in my kit. I have a green 270 Ohm 5W resistor (pic attached).
I assume that the "270W" in the manual is a misstype and the green 270 Ohm resistor that I have is the correct part?
Thanks in advance
I also have noticed the same thing and asked the same question in an email to bottlehead wondering if the part was missing in my kit. So if you are a moron...you're not the only one :)
-
Yup, that's the correct substitute.