Bottlehead Forum
General Category => Technical topics => Topic started by: Jamier on March 22, 2019, 07:28:30 AM
-
I am assembling a small push pull tube amp. With respect to the OT wiring path, should the B+ Supply be seperated from the plate wires, as far as possible, or should it be twisted together with the plate wires in the run to the OT?
Jamie
-
I'd post up pictures of how you have things laid out. Is the output stage ultra-linear?
-
PB,
It's not U/L. The OT path is coming out of a PCB and to a terminal block next to the OT. I am using the terminal block to facilitate ease of removal for changes/mods, so that may negate any noise controlling measures, like twisting, but I need the quick and easy removal that the term block provides.I assume that if it was U/L I should twist the plate and screen wires together? The PS is a simple CRC and the OT B+ comes off the reservoir cap, so I figured it might still have a lot of ripple.
Jamie