Bottlehead Forum

Other Gear => Headphones => Topic started by: xcortes on November 05, 2010, 07:33:41 AM

Title: K1000s and amp impedance.
Post by: xcortes on November 05, 2010, 07:33:41 AM
Ironbut will laugh at me because I told him that with my R10s I would never need another set of cans but I couldn't pass up a set of near mint AKG K1000s. And since these are not headphones but "earspeakers"...

I plan on rebuilding my Parabees with DC heaters for them. I assume I should use the 16 ohm tap, right?
Title: Re: K1000s and amp impedance.
Post by: Doc B. on November 05, 2010, 07:46:41 AM
That's what we're using with the Paramounts and K1000s. That way you will get the maximum voltage swing possible from the OT secondary while the output impedance is still plenty low for the K1000 load impedance of 120 ohms.
Title: Re: K1000s and amp impedance.
Post by: johnsonad on November 05, 2010, 01:18:01 PM
If those K1000's don't work for you, let me know.  I've been looking for a mint pair.
Title: Re: K1000s and amp impedance.
Post by: tdogzthmn on February 24, 2011, 06:27:28 PM
After recently hearing Doc's K1000 at the SF head-fi meet I can defiantly see why many people set these as their high bar for headphones.  I would really like to buy them however I feel that the HD800 is also very good.  Would anyone who own's both be able to comment on how the two headphones differ in sound? 
Title: Re: K1000s and amp impedance.
Post by: mrarroyo on February 25, 2011, 12:11:18 AM
IMO these two cans sound very differently, I prefer the K1000 by a good margin. The HD800 are very comfortable and after a good couple hundred hours of burn in sound quite pleasing. However they lack involvement and fun factor. The HD800 like the K1000 need a very good amp and they scale nicely as the source and amp improve, the best sound out of the HD800 I have heard was with a Luxman P1 amp that retails for about $2,500.

The "headstage" of the K1000 is way wider and it also places the instruments much better.
Title: Re: K1000s and amp impedance.
Post by: Doc B. on February 25, 2011, 05:29:57 AM
I agree that they are different. The K1000s are the kings of getting the music out of the middle of your head. They create a very speaker-like experience. The downside is that you share the experience with everyone nearby, even moreso than open back headphones. The HD800 does a very good job of getting the music out of your head too, I'd say second best of the cans I have listened to. But they do lack a bit of space and air that the K1000s have. The slight downside I find with the K1000s is that you need to pivot them in a bit from the position that gives the best soundstage to get the best bass or they can sound lean. The HD800s have a nice full bodied sound.

They are both rather odd to wear and quite different feeling. The K1000s only clamp on your head, not over your ears, and that creation of a smaller pressure point on the head was a cause of complaints by some folks at the meet. The HD800s have really huge earpads so they really spread the load evenly, but they can feel a bit claustrophobic and overly warm as they trap a lot of the heat coming off your cheeks. I would strongly suggest trying both on to see how they work for you. You look equally silly wearing either one, earning top geek style ratings.

By the way I can't say this on the Head-Fi forum without looking like I'm trying to advertise, but I would hope that folks would consider the amps that were running the K1000s as partly responsible for the comments about the K1000 sound we get at meets. I consider the Paramounts and K1000s a system, and I don't really feel that the Ks will sound the same with other amps.
Title: Re: K1000s and amp impedance.
Post by: ironbut on February 26, 2011, 07:09:04 PM
Yeah,.. that's one of those little headfi mysteries Doc.
I woulda thought that a pair of Paramounts would be on K1k lovers short list of must tries. Instead it's hairshirt sand amps like Alephs/F1-2-3, or big money 300b SET's (which do sound great but spending the cash on a Zanden or AirTight is a little extreme).
Kooky stuff but of course, that isn't exactly exclusive to the K1000 owners.
Title: Re: K1000s and amp impedance.
Post by: tdogzthmn on February 26, 2011, 07:24:28 PM
I appreciate your opinions, as I have only heard these headphones at meets which are not the best circumstances for forming accurate opinions of gear.  I really like the look of the K1000 which is unlike any other headphone ever made, also the fact that it is several years younger than the HD800 but can still keep up says alot for it.  I do see a K1000 in my future, but I have other priorities at the moment so a purchase will have to wait.  In the meantime I will have to make do with its little brother the K500 which is no slouch and does a great job with jazz and classical pieces.