Bottlehead Forum

Bottlehead Kits => Bottlehead Power Cord Kit => Topic started by: Jimb0 on March 30, 2020, 03:09:11 PM

Title: Continuity Question
Post by: Jimb0 on March 30, 2020, 03:09:11 PM

Tested the continuity but I'm getting 0.001 for all three pins
I set my voltometer to AC/2v like in the picture

Is this okay?

Title: Re: Continuity Question
Post by: Doc B. on March 30, 2020, 04:14:49 PM

That's the wrong end of the knob you're looking at. It's pointing to the continuity setting in the ohms scales at about 7:30 rather than the 2VAC scale at 1:30. If you don't have a continuity beeper on your meter you can just use your lowest ohms scale.

Title: Re: Continuity Question
Post by: Jimb0 on March 31, 2020, 08:44:26 AM

perfect thanks Doc! I got 0.3 ohms for each reading

Title: Re: Continuity Question
Post by: Doc B. on March 31, 2020, 09:40:33 AM

Sounds like you're good to go.