Bottlehead Forum
Bottlehead Kits => Mainline => Topic started by: oguinn on May 20, 2020, 09:37:58 AM
-
Trimming of the lead notwithstanding, does this look like a properly installed trim pot? This is the A side and the bent over lead is under the screw.
-
I don't see any issues. Even if you bend the middle lead to the wrong side and solder it down, the amp will still work 100% properly, you'll just have to adjust the trim pot the other way to get the desired result when setting the bias.
-PB
-
Cool, thank you. Mostly wanted to make sure I interpreted the instructions correctly.