Bottlehead Forum

Bottlehead Kits => Crack-a-two-a => Topic started by: Markkr on January 22, 2021, 02:01:26 PM

Title: 7 pin socket question
Post by: Markkr on January 22, 2021, 02:01:26 PM

Is it expected to have to drill the top plate holes to fit the 7 pin sockets? They do not fit inside the existing holes.

Title: Re: 7 pin socket question
Post by: Markkr on January 22, 2021, 02:22:35 PM

Disregard, found same post on page 2 :-)

Title: Re: 7 pin socket question
Post by: Paul Birkeland on January 22, 2021, 02:40:00 PM

The sockets we have been getting grew on us a little bit, and some panels went out without enlarged 7 pin holes.  A round file will nudge the hole size up a little bit to get the socket in.

Title: Re: 7 pin socket question
Post by: Markkr on January 22, 2021, 03:36:53 PM

Quote from: Paul Birkeland on January 22, 2021, 02:40:00 PM

The sockets we have been getting grew on us a little bit, and some panels went out without enlarged 7 pin holes.  A round file will nudge the hole size up a little bit to get the socket in.

Thanks thats exactly what I used, all good now.