Bottlehead Forum

Bottlehead Kits => Moreplay => Topic started by: IntarsiaGuy2 on August 05, 2021, 09:55:04 AM

Title: Instructions Questions
Post by: IntarsiaGuy2 on August 05, 2021, 09:55:04 AM

Hello,

I am not understanding the instructions towards the end.  Bottom of page 54 it says to bend a 220 ohm resister lead as in the picture. Next step is to install the resister through terminals A5/A6.  I can't tell from the picture how the resister bent this way is installed and would appreciate come clarification.

Thank you

Title: Re: Instructions Questions
Post by: Paul Birkeland on August 05, 2021, 10:01:06 AM

You bend the resistor into a U shape in the first step.  The unbent end goes into A6 and the bent end goes into A5.

Title: Re: Instructions Questions
Post by: IntarsiaGuy2 on August 05, 2021, 10:03:19 AM

Thanks