Bottlehead Forum
Bottlehead Kits => BeePre => Topic started by: RestoredSparda on March 03, 2022, 11:28:10 AM
-
Good afternoon!
Just completed the C4S board install and was wondering if my voltages are close enough at terminals 1 and 11. Instead of 150VDC I am reading 159.8 VDC.
Thanks!
-
That's nothing to worry about.
-
Sounds good. Thanks Paul. 👍
-
Same here, but a hefty 185V on the 1 and 11 after installing the C4S on a BeePre2
120V on the 6 and 16. 4 LED's up and bright.
Line voltage 234V;
Should and where can I troubleshoot?
-
Line voltage 234V;
Should and where can I troubleshoot?
No troubleshooting is required. If you're wired for 230V, you could move one wire and go to 240V wiring if you'd like.
-
Thanks!
-
Paul- I'm in the same boat. Just finished installing C4S board.
I read 168V on terminals 1 and 11.
Terminal 6 is 165V. Terminal 16 is 111V.
Permission to move on to the second part of the quiet upgrade?
-
Yes, that is OK.
-
Awesome. Thanks as always.