Bottlehead Forum
General Category => General Discussion => Topic started by: oguinn on March 23, 2023, 05:14:18 AM
-
Ages ago there was a thread about how best to babyproof the amp against curious children’s fingers. I can’t find it. I seem to recall the suggestion was a perforated board or a mesh of some sort but wanted to see if anyone had a solution that kept someone from reaching under the chassis and shocking themselves but still allowed for adequate airflow.
-
I would use a sheet of perforated aluminum screwed to the bottom of the base. It must have a drain wire attaching it to the chassis plate so that it has continuity with the safety ground.
-
I would use a sheet of perforated aluminum screwed to the bottom of the base. It must have a drain wire attaching it to the chassis plate so that it has continuity with the safety ground.
Thanks, Doc. Just attached to any of the ground points is ok?
-
This is where I get what I use:
https://www.customcargrills.com/Custom-Grill-Mesh.asp (https://www.customcargrills.com/Custom-Grill-Mesh.asp)
-
Attach the drain wire from the bottom panel to the safety ground tab on the chassis panel.
-
Thanks guys!