Bottlehead Forum
Bottlehead Kits => Crack => Topic started by: sbelyo on December 19, 2011, 10:08:22 AM
-
While inspecting my crack for another problem I noticed that one of the bleeder resisters for the output caps lookeda little toasted, but it measured fine.
Any thoughts on what would cause that?
-
There should never be a lot of voltage there, and therefore very little current to cause it to burn. Could it be from installation, the soldering iron getting to close?
-
no, it was pristine when I built it. The amp functions normally and the offset was within the limits. Just thought it strange when I saw it
-
Then clip on your meter leads and turn on the amp. See what kind of voltage gets across this resistor. Post your results.