Bottlehead Forum

Bottlehead Kits => BeePre => Topic started by: dw on February 20, 2013, 04:57:58 PM

Title: Assembly technique
Post by: dw on February 20, 2013, 04:57:58 PM

This has probably been mentioned before -
I found this to be very helpful on this build.

I have a computer screen at my build site, right next to the work. The intructions pdf file is open at the current build step
on one side of the build and a printed copy on the other. A glass of wine behind.
I use the printed copy to check off the steps I've made and underline stuff, like the pin and terminal numbers.
I use the computer screen to view and enlarge the pictures. The pictures are quite good quality.

Of course, my build may smoke when I power it up. If it does, I'll tell you, and you can ignore anything I've said.

- Dave

Title: Re: Assembly technique
Post by: earwaxxer on February 20, 2013, 05:04:27 PM

proper positioning of the glass of wine is probably the most important detail...

Title: Re: Assembly technique
Post by: Grainger49 on February 21, 2013, 12:46:48 AM

Dave, you are right.  I couldn't fit them all on my work table so I had the computer behind.  I had read through my instructions (Eros was my last build) and highlighted areas that I wanted to be sure to observe. 

Eric, the wine glass is positioned to the lips after successful completion of each step.