Bottlehead Forum
General Category => All things MagneQuest => Topic started by: Paul Joppa on February 26, 2013, 05:01:11 PM
-
Hey all, just a short note to say I put up a DIY design on Mike's board, using a 2A3 with the Robin Hood output transformer. Not parafeed or anything, just the simplest design I could do at the lowest cost - since the RH transformers are Mike's contribution to low-cost SETs.
http://www.audioasylum.com/forums/magnequest/bbs.html
Discussion should be on Mike's board, since this is not a Bottlehead thing at all. I only mention it because a lot of Mike's fans hang out here as well. :^)