Bottlehead Forum

Bottlehead Kits => Crack => Topic started by: univern72 on October 13, 2013, 08:26:43 AM

Title: Crack #6 Lockwashers
Post by: univern72 on October 13, 2013, 08:26:43 AM
Hi all,

I'm assembling my Crack and  I have no idea what to do with these 2 #6 lockwashers.

The instructions say the following about the nine pin socket:
Slip a #6 locknut on the screw from the underside and secure with a #4 nut.

I'm assuming "locknut" is supposed to be "lockwasher"? If so, this accounts for one of the lockwashers. Does the other one go on the other nine pin socket's screw? The manual isn't exceptionally clear on this.

Thanks!
Title: Re: Crack #6 Lockwashers
Post by: sjeffrey on October 13, 2013, 04:01:35 PM
I'm pretty sure that you just put the other lockwasher on the other screw for that socket.  At least that's what I did.
Title: Re: Crack #6 Lockwashers
Post by: ffivaz on October 13, 2013, 10:04:41 PM
Middle picture on page 22 of the manual shows the two locknuts under the two nuts of the 9-pin socket.