Bottlehead Forum
Bottlehead Kits => Legacy Kit Products => Stereomour => Topic started by: rlb6v6 on April 17, 2014, 03:07:27 PM
-
After five days of use, getting more amazing everyday, I noticed that my selector switch has four positions. Position 1 is my cd, Position 2 is my phono, Position 3 silent, (Input 3 is vacant), and the 4th position is the cd again. Wiring terminals were as in the instructions.
I have no problem with this arrangement, just a curiosity.
Anyone else get one of these?
Bob
-
If you remove the knob from the switch, undo the nut, and remove the lock washer, then slip the switch out of the plate, you'll then see a little metal ring on what would be the top of the switch.
This metal ring has a tab on it that sets the number of stops. If it slips a position, you'll get position 1 twice, or potentially just position 1 and 2 (if it slips the other way).
There's no harm in leaving it as-is, or you can move the ring one position. (Counterclockwise IIRC)
-
Thanks Paul, I will correct it, didn't even realize that was possible. I must add that the instructions are without a doubt the best of any I have seen! I have built three guitar amp kits, one scratch built guitar amp and a few effects pedals. NONE of which had the clarity that the BH instructions do.
Thanks to all involved in the production of these kits!
Bob
-
Thanks for the kind words, Bob!