Bottlehead Forum
Bottlehead Kits => Crack => Topic started by: Jim R. on May 03, 2010, 08:13:17 AM
-
I'm wondering if I got the right caps with my kit as the instructions say to bend the leads, but the caps I got are snap-ins with tiny little stubby leads. Is this correct?
Thanks,
Jim
-
Yes, the stubby leads need to be bent at a right angle so they can be soldered to the terminal strips.
-
Ok, it will probably make more sense as I'm doing the actual assembly. This is all just part of my pre-build prep work.
Thanks,
Jim