Bottlehead Forum
Bottlehead Kits => Legacy Kit Products => Smash => Topic started by: gh0st on September 02, 2014, 07:58:27 AM
-
My Smash must be coming up for shipping soon... starting to get excited ;D
One thing I wondered was whether I could dispense with the balance pot - I can't think of any time in the past that I've wanted to control left/right balance, is there a use case for this that I'm not aware of?
Would it be as simple as just to leaving it out and wiring the signal from the source-selector directly into the volume pot? It's not a big deal, but if I won't use it then it's a set of contacts that I could do without...
/dom
-
You can leave it out, but keeping the wiring stock will allow for the forthcoming attenuator upgrade to install properly (it dispenses with the balance control).
-PB
-
thanks!
-
Now I've got my kit and manual, can I just confirm that without the balance control I'd just wire the outputs from the input switch directly to the volume pot, dispensing with the 33K Raux resistors?
-
Yes, that is correct.
-
Cheers Paul.
-
You can leave it out, but keeping the wiring stock will allow for the forthcoming attenuator upgrade to install properly (it dispenses with the balance control).
-PB
Mmmm? Is the upgrade a dual mono setup?
-
The upgrade is a stepped attenuator, much like the Bee Quiet, which is a coarse/fine attenuator.
-PB