Bottlehead Forum
Bottlehead Kits => Legacy Kit Products => Smash => Topic started by: Chris65 on September 09, 2014, 11:57:31 AM
-
Hi, just a quick tech question - I noticed in the neat build thread by Stedes, that the 2 outputs are tied together on each side by resistors.
Just wondered the reason for that? Does that not attenuate the signal into the 2nd outputs (unless a very low value resistor).
Thanks,
Chris
-
The resistor value is very, very low. This was a suggestion from PJ, but I can't quite remember why...
-
Thanks PB, I guess there's some reason.... ;)
-
Hi all...would be interesting to know why. However to me (audibly) there is no difference between the two sets of outputs.