Bottlehead Forum
Bottlehead Kits => Stereomour II => Topic started by: [email protected] on June 29, 2015, 02:57:44 PM
-
Finished assembly last night, now on to resistance checks. Everything is OK except for #32. Manual shows a * but it reads 0 ohms. Both 29 and 32 are part of the ground bus (page 35) so i would expect it to read 0 ohms. All other resistance checks (including change in #45) check OK.
-
Yup, looks like a typo.
-PB
-
Thanks, from looking at the ckt and comparing the symmetric layout it seems it had to be 0 ohms, but since this is a new kit I just wanted to be doubly sure before applying power. Hard to put the smoke back in.