Bottlehead Forum
Bottlehead Kits => Legacy Kit Products => Quicksand => Topic started by: frank bare on February 13, 2016, 05:03:05 AM
-
Just completed build on Quicksand. What is with an occasional popping sound? Rechecked solder joints and re-seated chip.
Amp otherwise performs great! Paired with Quickie.
Thanks again for your help,
Bare
-
Maybe the batteries on the quickie or quicksand are low? Voltage starvation could cause pops.
-
Thanks for the update. The batteries are all new. Perhaps it could be one of the Quickie tubes? It doesnt happen often,
but if I leave it on without music playing I'll get an occasional pop.
Bare
-
I had the same problem.
I had to resolder all the connection for the filament heater and it worked like a charm, untill I discover I have a fault tube socket.
Try to move a bit the tube and see if it causes pops too.
But please, wait also the response of the Bottlehead crew before tryig anything!
Ciao!