Speedball Resistance issue (?) [Resolved]

Starionn · 1098

0 Members and 1 Guest are viewing this topic.

Offline Starionn

  • Newbie
  • *
    • Posts: 6
on: June 27, 2018, 04:14:08 PM
I searched around a bit and found https://bottlehead.com/smf/index.php?topic=10613.0 thread, but I just wanted to check, since my situation is close but slightly different.

When I measure the resistance at OB on the speedball, my meter says O.L. When I measure OA, though, it does shoot up into the millions of ohms. If it read O.L. for both I might be less concerned, based on that previous thread, but since I am getting a reading for one of them, I am less sure. Any thoughts? Thanks!
« Last Edit: June 28, 2018, 06:05:07 AM by Caucasian Blackplate »



Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19772
Reply #1 on: June 27, 2018, 04:36:51 PM
Millions of ohms is just as good, I would proceed to the voltage checks.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline Starionn

  • Newbie
  • *
    • Posts: 6
Reply #2 on: June 27, 2018, 05:56:31 PM
Thanks a lot! Voltage checks went fine and it's up and running with the speedball in play. :D