Newly finished initial build on the Stereomour. In doing initial resistance checks, everything checks OK, save for one measurement.
Here is situation:
-Resistance check to terminal 11 gives no reading
-This terminal is B side connection to output transformer, A side reads fine (1.4K ohms)
-Checked connections, resoldered
-Desoldered both ends of wire, checked wire continuity - 0 resistance, resoldered, still no luck
Only additional clue is that the OT-2 terminal #5 (terminating connection from terminal 11) is loose in the OT-2 unit. I suspect the connection is faulty internal to the OT-2 unit.
Any additional suggestions? My first build BTW.
Steve