Hi PB, R4 on bias board

Thermioniclife · 1354

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Thermioniclife

  • Sr. Member
  • ****
    • Posts: 794
on: May 23, 2020, 05:38:28 AM
Hey, did you guys recently change to a Vishay PR01 type resistor at R4 on the bias board?
Have a good Holiday.

Lee R.

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19750
Reply #1 on: May 23, 2020, 06:10:22 AM
Yes, you can see that part in the final build photo.  The old 220K resistor that we used to use kept going in and out of stock so we switched over.  When we tweaked the manual for the universal power transformer, we didn't end up reshooting the whole manual, just the build and installation of the power supply board and the wiring of the power transformer.

-PB

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Thermioniclife

  • Sr. Member
  • ****
    • Posts: 794
Reply #2 on: May 23, 2020, 06:25:08 AM
Roger that, Thanks.

Lee R.

Pages: 1   Go Up
« previous next »