Crack first build issues

lizzyandbandit · 1144

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline lizzyandbandit

  • Newbie
  • *
    • Posts: 3
on: July 06, 2020, 11:21:27 AM
On my first build with the Crack and may be stuck.  Is my negative test lead in the correct place for ground buss 12U? Attached are my resistance values and they seem to be off for #4 and #5? I have re-soldered, but didn't seem to make a difference. Thanks for any input!

Mark Brooks

Offline lizzyandbandit

  • Newbie
  • *
    • Posts: 3
Reply #1 on: July 06, 2020, 11:24:42 AM
resistance values

Mark Brooks

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19778
Reply #2 on: July 06, 2020, 11:35:05 AM
When your meter says "3" for terminal 1, is there a unit after that?  Is it 3M ohms?  3K ohms?

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline lizzyandbandit

  • Newbie
  • *
    • Posts: 3
Reply #3 on: July 06, 2020, 12:37:30 PM
I left the clip on T1 for a bit and it worked its way down to .254M. T2 = .445M. When I left it clipped on T4 longer, it settled on 186K. T5 = .229M.

Mark Brooks

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19778
Reply #4 on: July 06, 2020, 02:19:02 PM
OK, those are numbers that are OK and far more descriptive than what you had listed before. 

You might want to go back through the resistances and recheck them just to be sure.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Pages: 1   Go Up
« previous next »