Tube socket PCB

Markkr · 860

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Markkr

  • Full Member
  • ***
    • Posts: 70
on: January 16, 2021, 04:44:40 PM
Is there any reason to avoid using tube socket PCB’s to clean up those connections a little?


Deke609

  • Guest
Reply #1 on: January 16, 2021, 05:24:39 PM
Those make sense to me. The only caution I can think of is regarding the use of grid stopper resistors to prevent/minimize oscillation. Since they work best if connected with little to no lead between the body of the resistor and the grid pin, if a build calls for grid stoppers you might want to wire them directly to the grid pins and not to the pcb holes connected to the pins.  Just a thought.

cheers, Derek


Offline 2wo

  • Hero Member
  • *****
    • Posts: 1260
  • Test
Reply #2 on: January 16, 2021, 06:10:35 PM
You're adding an additional solder joint to each pin...John

John S.

Offline mcandmar

  • Hero Member
  • *****
    • Posts: 1599
  • Not all engineers are civil
Reply #3 on: January 17, 2021, 01:46:12 AM
Pretty sure those will only fit the CMC style tube sockets with pins.  I have used them a few builds with no issues.

M.McCandless

Offline Markkr

  • Full Member
  • ***
    • Posts: 70
Reply #4 on: January 17, 2021, 04:13:32 PM
Excellent, thanks for the input!


Pages: 1   Go Up
« previous next »