Crack voltages wrong [resolved]

bryan · 1167

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline bryan

  • Newbie
  • *
    • Posts: 4
on: June 01, 2021, 06:50:39 PM
Checked the resistances and they were OK.

Terminals 5 and 9 are around 150V-200V
all other voltages seemed fine.

LED from A3 to center pin is not lighting up
« Last Edit: June 02, 2021, 12:02:24 PM by Paul Birkeland »


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19757
Reply #1 on: June 01, 2021, 08:16:51 PM
What is your voltage at A3?  Are both halves of your 12AU7 glowing?

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline bryan

  • Newbie
  • *
    • Posts: 4
Reply #2 on: June 02, 2021, 10:40:25 AM
Both sides glow and a3 is at around a volt.

I re-soldered the joints and It seems to have fixed the problems. Thanks for the suggestions.


Pages: 1   Go Up
« previous next »