rectifier section

Knightstick · 1121

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Knightstick

  • Full Member
  • ***
    • Posts: 78
on: June 18, 2021, 03:00:50 AM
Hello all! I have a question about the length of a diodes leads that connects 19L and 21L. It says in the manual to bend the leads 5/8" from the body of the diode. That seems to leave it too long to be able to insert into the holes. Is this maybe a minor discrepancy? I just don't want to fry anything by putting it in the wrong place. Thanks much in advance.

Adam

Online Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19772
Reply #1 on: June 18, 2021, 05:39:27 AM
You can bend them in a little bit and use that spring tension to hold the diode in place while you're soldering, or you can reduce the bend distance to 9/16".

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Knightstick

  • Full Member
  • ***
    • Posts: 78
Reply #2 on: June 18, 2021, 05:59:54 AM
I'm sorry, I'm still a bit confused. Does this look okay? I left the leads just in case.

Adam

Online Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19772
Reply #3 on: June 18, 2021, 07:23:25 AM
Should be OK.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Knightstick

  • Full Member
  • ***
    • Posts: 78
Reply #4 on: June 18, 2021, 07:34:37 AM
Thank you PB. I appreciate all your help!

Adam

Offline Deluk

  • Sr. Member
  • ****
    • Posts: 440
Reply #5 on: June 19, 2021, 01:13:13 AM
Bend the wire ends fully round the tags to make a proper mechanical joint before final soldering. Trim off any excess length of lead e.g. diodes.
Fully heat a joint and allow the solder to flow properly before quickly removing the iron. No touch up dabbing!


Pages: 1   Go Up
« previous next »