DC upgrade

Knightstick · 2080

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Knightstick

  • Full Member
  • ***
    • Posts: 78
on: March 01, 2022, 09:19:27 AM
Hello, I've been working on my Stereomour today upgrading it with the DC Filament parts. I'm at the end installing the .13 ohm resistors. While putting one of them in I had the iron on it awhile, and the resistor turned a light brown. After adjusting it to attach it to the other terminal a small piece of the ceramic fell off. I see metal but no visible signs of burning on the metal.Thanks much for any help

Adam

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19774
Reply #1 on: March 01, 2022, 02:08:30 PM
It would take a ton of heat and effort to actually damage one of those, so I wouldn't be super concerned about overheating one.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Knightstick

  • Full Member
  • ***
    • Posts: 78
Reply #2 on: March 01, 2022, 03:22:56 PM
Thank you as always Paul.

Adam

Pages: 1   Go Up
« previous next »