Chassis/End Bell

btol · 2388

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline btol

  • Jr. Member
  • **
    • Posts: 26
on: November 14, 2022, 03:19:46 PM
Moreplay is arriving tomorrow and I'm reading through the manual. I notice the manual is recommending only the top side of the chassis and end bell be painted for proper grounding. Does this still apply if I were to have them powder coated? I imagine it's not really possible to just powder coat one side...


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19750
Reply #1 on: November 15, 2022, 04:06:23 AM
You can scrape off the powder coating around the bottom side of the mounting holes when you get it back from the powder coater.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline btol

  • Jr. Member
  • **
    • Posts: 26
Reply #2 on: November 15, 2022, 06:59:03 AM
Quote from: Paul Birkeland on November 15, 2022, 04:06:23 AM
You can scrape off the powder coating around the bottom side of the mounting holes when you get it back from the powder coater.

Thank you PB!

If I were to ditch the powder coating and just went with the bare chassis/end bell, is this good for sealing the end bell and preventing rust?

Rust-Oleum 285093 Stops Rust Spray Paint, 12 Oz, Matte Clear


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19750
Reply #3 on: November 15, 2022, 08:53:10 AM
Any paint on the cover will do the job, other than water based variants I suppose. 

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Pages: 1   Go Up
« previous next »