Chassis plate thickness?

paulw · 14592

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline paulw

  • Full Member
  • ***
    • Posts: 80
  • 2A3 = Music
    • My Hobby Site
on: January 29, 2010, 04:39:07 AM
Hi can someone give me the thickness of the top plate please?

Paul

Paul Williams
Acoustic Signature Challenger (with 3 arms) Entre SUT+Seduction, Smash(out) & Quickie(in again), Paramour II's, 7 Pi Corner Horns or Quad 44, Quad 405-2 & Videoton Minimax GB3.

Offline TimH

  • Newbie
  • *
    • Posts: 4
Reply #1 on: January 29, 2010, 04:20:30 PM

mine is 0.112 inch, just a little under 1/8

Tim


Offline paulw

  • Full Member
  • ***
    • Posts: 80
  • 2A3 = Music
    • My Hobby Site
Reply #2 on: January 29, 2010, 10:51:43 PM
Thanks Tim - so standard 3mm(ish) - just a bit of forward planing for a case for the Quickie.

Paul

Paul Williams
Acoustic Signature Challenger (with 3 arms) Entre SUT+Seduction, Smash(out) & Quickie(in again), Paramour II's, 7 Pi Corner Horns or Quad 44, Quad 405-2 & Videoton Minimax GB3.

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19757
Reply #3 on: January 30, 2010, 10:16:04 AM
The plates are indeed 3mm, although the manufacturer specifies that this is 1/8".  To offer the best quality plate, I pretty much exclusively get cast material, as it is more tolerant to chemicals, heat, etc.  Unfortunately, the thickness tolerances on cast acrylic are all over the place...

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Pages: 1   Go Up
« previous next »