Above Chassis Bias - Part Deux (Question for PJ)

Paully · 2602

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Paully

  • Sr. Member
  • ****
    • Posts: 516
on: September 17, 2011, 04:47:02 AM
Paul, you helped me when I was putting in some bias pots above the chassis for 45 tubes.  If memory serves we used some diodes and a 1.1K and a 3.3K resistor per board.  If I want to play around with some 300B tubes and convert my Paramount back do I need to change the values of those resistors?


Offline Paul Joppa

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 5833
Reply #1 on: September 18, 2011, 07:00:26 AM
Those resistors and that circuit are not useful for the 300B; they are specific to the direct coupled setups. It's in the manual - different driver plate voltage settings for 2A3 and 300B.

Paul Joppa

Offline Paully

  • Sr. Member
  • ****
    • Posts: 516
Reply #2 on: September 18, 2011, 08:38:35 AM
All right, thanks for the response!  I will look in the manual.


Pages: 1   Go Up
« previous next »