High / Low gain switch on SEX 2.1

Todd R · 2272

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Todd R

  • Full Member
  • ***
    • Posts: 135
on: December 21, 2011, 11:50:27 PM
My source apparently is higher than normal, so I'm getting all the volume I need by 9:00 on the knob (Using HD-650's).
Would there be a good place to install a high / low gain switch somewhere in the circuit?
If so, how would you go about doing it?


Offline Grainger49

  • Hero Member
  • *****
    • Posts: 7175
Reply #1 on: December 22, 2011, 06:15:56 AM
There are a number of ways of "padding" the input.  On this page from VoltSecond's site you are given a number of options for lowering the input voltage before it gets to the tubes:

http://www.siteswithstyle.com/VoltSecond/12_posistion_shunt/12_Position_Pure_Shunt.html


Pages: 1   Go Up
« previous next »