I know there has been a lot of comment about readings, but I hope someone will tell me what they think is going on with mine.
I get 3.3 V at 1a and 1b (my manual says it should be 37-38), the readings at 5a & 5b(1.7V), and 6a & 6b (21.6V) are all about what they should be. I have the D cell batteries reversed in the holders per forum advice. Maybe I should say that my kit is about 2 years old, I built the Quickie but I'm just getting around to the PJCCS. I had to get Bottlehead to send the proper PCB, which they did promptly and pleasantly. I think I checked the resistor values correctly, I could have made like a 470K vs. 470 error, but they look like the ones in the manual. After I checked all my connections, I decided to take it outside and fire it up. It sounded pretty darn good, so maybe the readings in the manual are not correct for pin 1?
Thanks
