Resistance Check

ashneel · 1687

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline ashneel

  • Jr. Member
  • **
    • Posts: 38
on: March 21, 2013, 08:48:00 AM
I recently installed an ALPS pot on my Crack ( I have no idea if its because of that) . Voltages check are all ok..Resistance checks are all pinpoint except for the Center Pin resistance check.
In the manual, it it stated they should be between 90K Ohms-100K Ohms. I am getting 105K Ohms and 106K Ohms..

Should I worry about that ? Someone please help..
« Last Edit: March 21, 2013, 08:50:37 AM by ashneel »


Offline adamct

  • Sr. Member
  • ****
    • Posts: 755
  • Maxxximum CAPacity Crack
Reply #1 on: March 21, 2013, 09:47:08 AM
No, that should be fine.


Offline ashneel

  • Jr. Member
  • **
    • Posts: 38
Reply #2 on: March 21, 2013, 10:01:17 AM
Thanks for the help mate..I was worried that it may cause imbalence. It didn't..
« Last Edit: March 21, 2013, 10:12:51 AM by ashneel »


Pages: 1   Go Up
« previous next »