burnt out resistors

coors · 4557

« previous next »
Pages: 1 2   Go Down

0 Members and 1 Guest are viewing this topic.

Offline coors

  • Jr. Member
  • **
    • Posts: 27
Reply #15 on: March 24, 2013, 03:33:18 PM
I was using Cardas solder.  Anyway I re soldered the area and did connect the terminals to ground and now all is good,  thanks for all of the help. 
It must have been excess flux not allowing a good connection and producing a short?  Good eyes by the way diagnosing the problem with the photo
Now on to add the Speedball!

Sam


Offline Grainger49

  • Hero Member
  • *****
    • Posts: 7175
Reply #16 on: March 25, 2013, 12:08:44 AM
Cardas is what I use.  I'm surprised at the obvious flux seen in the pictures. 


Pages: 1 2   Go Up
« previous next »