Speedball Upgrade problem & Gears setup question

hnguyen · 4882

« previous next »
Pages: 1 2   Go Down

0 Members and 1 Guest are viewing this topic.

Offline hnguyen

  • Newbie
  • *
    • Posts: 8
Reply #15 on: September 28, 2014, 05:13:33 PM
It sounds good to me (i feel it is better than my Crack before upgrade). However, I am by no mean an expert in this field. The sound is clear, both channels work. So can I just ignore that LED?


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19757
Reply #16 on: September 28, 2014, 05:15:30 PM
That's probably what I would do if the voltages look good.

I might also be looking at the solder joints on the bottom of the board, clean, shiny joints with just enough solder to fill up each through hole on the board will actually make the amp sound a bit better.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline hnguyen

  • Newbie
  • *
    • Posts: 8
Reply #17 on: September 28, 2014, 06:03:19 PM
Thanks for your help. I will definitely take a look at it again. 


Pages: 1 2   Go Up
« previous next »