Resistance Checks

coldjoint · 1264

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline coldjoint

  • Newbie
  • *
    • Posts: 2
on: January 15, 2015, 03:14:14 AM
First, thanks to all at Bottlehead for a great kit.  I've really enjoyed building the Crack.
I have a question for which I would be glad for some help.
I've done the resistance checks and the results seem ok except I can't quite get 0 ohms where I'm supposed to.
My DMM usually starts at about 2 or 3 ohms, and the reading then gradually drops to 1.4 or 1.5 ohms but doesn't go lower.
Do I have a short somewhere?
I should add that with nothing connected, touching the probes of my DMM shows about 0.4 or 0.5 ohms.  It never goes to zero.



Offline Strikkflypilot

  • Sr. Member
  • ****
    • Posts: 459
  • Shellac fiddler
Reply #1 on: January 15, 2015, 07:37:03 AM
What does it show when You hold both probes together?

Home system:
Sources: Ibasso DX90, Google Chromecast Audio optical out
DAC: Schiit Gumby
Amp: Bottlehead Mainline
http://bottlehead.com/smf/index.php?topic=7463.0
Phones: HD800S

Office:
Sources: Iphone/ Ipod
DAC: Dragonfly Red+Jtrbug
Amp: Crack/Speedball heavily modded
Phones: HD580,HD600 grilles

Offline Doc B.

  • Administrator
  • Hero Member
  • *****
    • Posts: 9659
    • Bottlehead
Reply #2 on: January 15, 2015, 07:40:39 AM
Your zero readings are fine. There will be some small resistance present in any test setup.

Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.

Offline coldjoint

  • Newbie
  • *
    • Posts: 2
Reply #3 on: January 16, 2015, 08:24:37 PM
Thanks Doc, hope to run the voltage checks this weekend!


Pages: 1   Go Up
« previous next »