Upstream component change eliminated noise I thought was from my amp

physicsmajor · 1552

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline physicsmajor

  • Jr. Member
  • **
    • Posts: 47
on: March 09, 2015, 08:01:14 PM
Spoke too soon last night. Noise level is massively improved, but it must be due to upstream components as the noise is essentially identical balanced or unbalanced from the speaker taps.

Turns out the S.E.X. has been illuminating upstream deficiencies all along, getting no respect for it.

Apologies for the hasty overreach of a post...
« Last Edit: March 10, 2015, 12:51:35 PM by physicsmajor »


Offline mcandmar

  • Hero Member
  • *****
    • Posts: 1599
  • Not all engineers are civil
Reply #1 on: March 10, 2015, 04:49:10 AM
Curious.  I guess in theory balanced wiring is supposed to cancel out common mode noise but i'm surprised it is noticeable at such a short distance.

Also the HE-500's aren't very efficient so if your hearing background noise with them the noise floor on the amp will be quite high.  To the point i would suspect something is wrong, bad solder joint, dirty tube contacts, or maybe just a noisy tube etc.

M.McCandless

Offline fullheadofnothing

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 1487
  • A noble spirit embiggens the smallest man
Reply #2 on: March 10, 2015, 07:14:19 AM
Have you tried the unbalanced position while connected to the speaker outs?

Joshua Harris

I Write the Manuals That Make The Whole World Sing
Kit Packer Emeritus

Offline physicsmajor

  • Jr. Member
  • **
    • Posts: 47
Reply #3 on: March 10, 2015, 12:52:22 PM
Attempted. Equally good. A bit more investigation and I think this must have been something upstream from the very start.

Updated the original post...


Pages: 1   Go Up
« previous next »