Buzzing sound even without source plugged in.

Demoninja · 1319

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Demoninja

  • Jr. Member
  • **
    • Posts: 12
on: March 17, 2015, 09:41:32 PM
Hey all, I'm back again. I managed to resolve my previous issue with not having audio in one side and the amp worked perfectly for a month or so. Recently the amp started buzzing. Nothing changed as far as I know, it just started out of nowhere. Any recommendations on where to begin troubleshooting?

Edit: So I believe this humming is related to voltages, I had a pair of headphones plugged in and I turned the amp off and the buzzing got noticeably louder until it went away. Before that the buzz would be consistent. I usually have it plugged into a power strip and when I plugged it into the wall directly I heard the buzzing even after the amp was turned off for quite a bit, maybe 2 minutes.
« Last Edit: March 17, 2015, 09:50:05 PM by Demoninja »


Online Doc B.

  • Administrator
  • Hero Member
  • *****
    • Posts: 9660
    • Bottlehead
Reply #1 on: March 18, 2015, 05:50:00 AM
Sounds like a loose ground connection somewhere in the amp. Probably time to go back under the hood and reflow some solder joints.

Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.

Offline Grainger49

  • Hero Member
  • *****
    • Posts: 7175
Reply #2 on: March 18, 2015, 07:02:00 AM
There is a sticky for the ground terminations of the Crack.


Offline Demoninja

  • Jr. Member
  • **
    • Posts: 12
Reply #3 on: March 25, 2015, 11:11:28 PM
Sorry for the delay, I just measured all the ground spots via the sticky that Grainger49 graciously put together. Unfortunately all of them measure out to a solid 0. I'll probably reflow them anyway but if my measurements are accurate then this might not be the problem. I'll edit this post in a few minutes with an update.


Pages: 1   Go Up
« previous next »