Crack + Speedball Smoked [resolved]

Colin · 1698

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Colin

  • Jr. Member
  • **
    • Posts: 34
on: April 09, 2016, 05:53:53 PM
Hi everyone, I need help(again).
My crack+speedball get smoked(on 270 R psu ) and smelted.

When turn on, started from tubes glowing and then 'very glowing' on 6 leds(small pcb 2 x 2 and 12au7 2), the big pcb not glow(sometimes has glow(2 led) a moment and then turn off again and sometimes only glow 1 led)

And after 'very glowing' moment, it's slowly goes glowing normal again in 2 pcb led(4), and the 12au7(2) automatically turn off.

Here is the voltage check :
1 1v
2 29v
4 28v
5 2v
7 0v
9 0v
13 28v
15 93v
21 0v

Every suggestion is very welcome and thanksfull.

Thank you,
Colin
« Last Edit: April 12, 2016, 01:59:38 PM by Caucasian Blackplate »


Offline fullheadofnothing

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 1487
  • A noble spirit embiggens the smallest man
Reply #1 on: April 11, 2016, 06:58:05 AM
You have incorrectly mounted your TIP-50 transistors. Re-read the instructions on page 15 and fix the error.

Joshua Harris

I Write the Manuals That Make The Whole World Sing
Kit Packer Emeritus

Offline Colin

  • Jr. Member
  • **
    • Posts: 34
Reply #2 on: April 16, 2016, 10:02:01 AM
Thank a lot. The problem already gone. 😊


Pages: 1   Go Up
« previous next »