Speedball installation question

Sektor7G · 1555

« previous next »
Pages: 1   Go Down

0 Members and 2 Guests are viewing this topic.

Offline Sektor7G

  • Jr. Member
  • **
    • Posts: 15
on: September 30, 2016, 05:08:34 AM
Greetings:
I have a Speedball kit on its way and in the meantime I have been studying the instructions ahead of time so I can be ready to build when it arrives. My question to the forum is: Would applying a small "I Mean tiny!!" amount of thermal paste between the TIP-50 transistor and the heatsink help dissipate heat better? Do you all think it would make an improvement at all? Am I just over complicating things?

Thanks.   


Offline Doc B.

  • Administrator
  • Hero Member
  • *****
    • Posts: 9662
    • Bottlehead
Reply #1 on: September 30, 2016, 05:15:59 AM
You are over-complicating things. You're not going to overclock a Speedball board. Build it just like the instructions say and it will work very well.

Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.

Pages: 1   Go Up
« previous next »