Bottlehead Crack Troubleshooting - 1 LED not lit and voltages amiss. [resolved]

[mjhara]

This is my third Bottlehead build, having done an Eros and Stereomour in the past, so I know enough to believe that this is likely a bad solder joint somewhere - however, I've resoldered most joints and am still coming up short. Resistance checks were all correct, but I am getting bad values for my voltage checks. They are as follows:

T1: 0 (expected 50-100V)
T2: 231V (expected 170V)
T3: 0
T4: 231V (expected 170V)
T5: 95 V (expected 100V)

T6: 0V
T7: 0V
T8: 0V
T9: 0V
T10: 0V

One of the two LED's is not lighting up as well.

Tubes both light up on both sides.

Any help you could offer would be greatly appreciated! Thank you.

[mjhara]

I just rechecked the tubes and I was incorrect - the 6080 is not lighting up, although it did the first time during the tube check earlier in the process.

[mjhara]

After resoldering some random seemingly unrelated joints it now works. Resolved!