Powerline Voltage Test

slackbits · 1059

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline slackbits

  • Newbie
  • *
    • Posts: 5
on: May 04, 2017, 01:55:16 PM
Hi all,
New here, and if the build continues to go as it starts, I will be writing to you all more.  I am doing the initial Powerline Voltage Test (just testing the leads connected to L & N) as on page 23.  My multimeter keeps showing 6-7v AC whenever I plug it in.  I tried searching the forums, but it looks like everyone else makes it past this level.  I am attaching a picture, but any ideas what might be up?

Thanks in advance!



Offline Doc B.

  • Administrator
  • Hero Member
  • *****
    • Posts: 9642
    • Bottlehead
Reply #1 on: May 04, 2017, 02:56:28 PM
Plug the test leads right into the live and neutral of your wall outlet and see what the meter reads.

Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.

Offline slackbits

  • Newbie
  • *
    • Posts: 5
Reply #2 on: May 04, 2017, 04:54:16 PM
Thanks for the reply Doc!  To answer *your* question 120v.  To answer *my( question it appears to be a bad set of alligator clips. :) Once I used the probes original leads, the test gave me 120v.  (Although since this is my first time using voltage greater than a battery, I am a bit skittish not using the clips and standing far away...)   Now I just need to find another set of clips.


Pages: 1   Go Up
« previous next »